I am getting an error related to fault rupture length. Its showing error related to JIT debugging.
How do i reomove it.. Infact all the models that I can use measure distance in Rrup. How do i remove it?
ERROR MESSAGE BY LOADING A MODEL
- 234 Views
- Last Post 07 June 2018
Content_Manager
posted this
06 June 2018
Dear Shaista,
The error you are getting appears when trying to load an existing model of R-CRISIS or in the middle of building of it. Please, be more specific on it to provide you a correct assistance.
If you desire, you can share with us the *.DAT file sending it to our contact e-mail r-crisis@ern.com.mx and we can review it.
Thank you for your interest in R-CRISIS.
Best regards,
shaista jan
posted this
06 June 2018
Sir
I mailed you the .dat file we made. Please have a look into the issue.
Regards
Content_Manager
posted this
06 June 2018
Dear Shaista,
We have checked your model and the problem is due to one of the seismic sources, probably, there is a problem with the geometry definition or any seismic parameter assignment, we suggest you to check it in detail.
Thank you for interest in R-CRISIS.
Best regards,
shaista jan
posted this
07 June 2018
Thank you so much. It did work.
shaista jan
posted this
07 June 2018
What does assigning a TIME FRAME mean? what time frame should we set?
Content_Manager
posted this
07 June 2018
Dear Shaista,
The Time Frame is the time for which seismic hazard will be computed. Generally, it is adopted as 50 years, however, this value must be correctly defined and checked by the analyst that is carrying out the seismic hazard assessment.
Thank you for your interest in R-CRISIS.
Best regards,
